Supertech ®
Thousands of Products
Serving You is Our Pleasure
Registered w/
Dun & BradstreetVOSB - Veteran Owned Small Business since 1973 NAICS CODE: 423450
Product Categories
Step Heater for Vehicles w/ Metal Steps
Safely Heats Metal Steps to keep them from Icing Up in Winter
Promotes safe step mounting for passengers & employees
Installs to underside of step
Full Contact Heater – spreads heat over the largest possible area
Can be sealed w/ rust proofer
Not subject to wear and tear of passenger traffic
On/Off Switch inside vehicle to activate heater when temp falls below 32° F or may be installed w/ optional automatic thermostat
Connects to a 12 Volt power source – crimp type connectors
Safe to Use
Easy to Use
Presently relied upon by several O.E.M. Bus Companies
Installation Instructions
The SH-267 Step Heater is installed on the bottom side of the entrance step.
The surface must be clean and dry prior to installation of the heater. Clean the surface where the heater is to be placed with Isopropyl Alcohol just before application of the heater. (Do not use Solvent based cleaners!) Make sure to allow the alcohol to dry completely before placing the heater on the step.
Peel the release paper from the back of the heater and place it (adhesive side up) in the center of the bottom side of the bottom entrance step.
Make sure that all parts of the heater contact the surface of the step.
Wire leads should be connected to a 12 Volt power source with crimp type connectors.
The heater's power circuit must have an in-line fuse or circuit breaker. Ultra Heat recommends the use of an on/off switch with the use of the SH-267 Step Heater.
Automotive undercoating can be put on the SH-267 after installation without any adverse effects.
Supertech ®
President: David B. McNitt
V.P. of Marketing: Judy McNitt-Mell
Asst. to the President: Joy E. NystrandAddress:
P.O. Box 186
Elkhart, IN 46515 USA
Sales: 800-654-1054
Phone: 574-264-4310
Fax: 574-264-9551
Email: sales@supertechx-ray.com
Support: support@supertechx-ray.com
